Falcon Elan 110 Instrucciones De Instalación página 41

Grill
Open the grill compartment door.
Turn on the grill control and check
that the grill heats up.
Oven check
The clock must be set to the time of
day before the ovens will work.
See the 'The clock' section for how
to set the time of day.
Turn on the ovens and check that
they start to heat up. Turn off the ov-
ens.
Fitting the plinth
Loosen the 3 screws along the front
bottom edge of the cooker. Hook the
central keyhole over the central
screw. Twist and fit each end keyhole
over their respective screws. Tighten
the fixing screws.
Oven Lights
Press the oven light switches and
check that the lights are working.
NB. The oven light bulbs is not in-
cluded in the guarantee
Customer care
Please inform the user how to oper-
ate the cooker and hand over these
instructions.
Thank you.
Conversion to another
gas
Servicing - warning
This conversion must be performed
by a competent person. After conver-
sion the installation must comply with
the relevant regulations and also the
local electricity supply company re-
quirements. Read the instructions be-
fore converting this appliance.
Failure to convert the appliance cor-
rectly could invalidate any warranty or
liability claims and lead to prosecu-
tion.
This instruction must be used in con-
junction with the rest of the appliance
instruction, in particular for informa-
tion on Standards, cooker positioning,
connection hose suitability etc.
When servicing or replacing gas-car-
rying components disconnect from
gas before commencing operation
and check appliance is gas sound af-
ter completion.
Do not use re-conditioned or unau-
thorised gas controls.
Conversion
Disconnect from electricity and gas
before servicing. Check appliance is
safe when you have finished.
This appliance is supplied as: -
G 20 20millibar
CAT II 2H3+
CAT II 2E3+
CAT II 2E3B/P
Check in the Technical Data section
at the back of the book that the
cooker is convertible to the gas you
want to use.
Injectors
Remove burner caps and heads. Re-
move old jets. Fit the new jets (see
Technical Data section at the back of
the book for correct jets). Reassem-
ble in reverse order.
Tap adjustment
Check in the table at the back of
the book to see if the bypass
screws need to be changed.
Pull off all the control knobs.
Open the oven door & grill door and
remove the fixing screws underneath
the control panel.
39
Remove the 2 handrail end-bracket
fixing screws, remove the 2 cross-
headed screws that were hidden by
the handrail end brackets.
Lower facia panel clear of top retain-
ing tags.
To convert to other gases.
Remove the bypass screw and fit the
correct replacement.
See table at the back of this book for
correct size.
Refit the control panel.
Stick on label
Stick the appropriate label on to the
data badge to indicate the gas the ap-
pliance is now set for.
Pressure Testing
Connect the appliance to the gas
supply. Check the appliance is gas
sound.
See Technical data section at the
back of this book for test pressures.
The gas pressure can be measured
at one of the centre hotplate burner
jets (not the triple ring burners). Lift
off a burner head. Fit the pressure
gauge to the jet. Turn on the hotplate
burner and turn on and light one of
the other burners.
Reassemble burner top, making sure
it is reassembled in the correct way
on the burner body.
Check the appliance is gas sound.
Check operation of all the burners.
English