Manufacturer's Warranty - Hilti PM 40-MG Manual De Instrucciones Original

Trouble or fault
The reception range is too
short
Laser receiver not receiving a
laser beam
9 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode if
damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or environmental
pollution. Careless disposal may permit unauthorized and improper use of the equipment. This may
result in serious personal injury, injury to third parties and pollution of the environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or
incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance with national
regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Do not dispose of electronic measuring tools together with household waste.
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device complies with Part 15 of the FCC Rules and CAN ICES-3 (B) / NMB-3 (B). Operation is subject
to the following two conditions:
1. This device shall cause no harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti may restrict the user's authorization to
operate the equipment.
20 English
Possible cause
Working in weak area of the laser.
Lighting conditions on site are too
bright
Light is shining directly into the
detection area.
The laser is not in receiver mode
The laser receiver is too far away
from the laser.
Action to be taken
▶ Work in the more effective area
of the tool (front and rear).
→ page 16
▶ Position the laser and / or the
laser receiver in an area where
the light is not as bright.
▶ Prevent light from shining
directly into the detection area,
for example by shading it.
▶ Activate the receiver mode on
the line laser.
▶ Position the laser receiver closer
to the laser.
2171411
*2171411*