Normal Maintenance - Chef's Choice Edgecraft E315 Manual Del Usuario

NORMAL MAINTENANCE

NO lubrication is required for any moving parts, motor, bearings or sharpening surfaces.
There is no need for water on abrasives. The exterior of the sharpener may be cleaned by
carefully wiping with a soft damp cloth. Do not use detergents or abrasives.
Once a year or so as needed you should remove metal dust that will accumulate inside
the sharpener from repeated sharpenings. Remove the small rectangular clean-out cover
(Figure 14) that covers an opening on the underside of the sharpener. You will find metal
particles adhered to a magnet attached to the inside of that cover. Simply rub off or brush
off accumulated filings from the magnet with a paper towel or tooth brush and reinsert
the cover in the opening. If larger amounts of metal or other dust have been created
you can shake out any remaining dust through the bottom opening when the cover is
removed. After cleaning, replace the cover securely with its magnet in place.
SERVICE
In the event post-warranty service is needed, return your sharpener to the EdgeCraft
factory where the cost of repair can be estimated before the repair is undertaken.
Outside the USA, contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of
the problem or damage on a separate sheet inside the box. Retain a shipping receipt as
evidence of shipment and as your protection against loss in shipment.
149 Cleveland Drive, Paris, KY 40361 U.S.A.
Made in the U.S.A. with U.S. and globally sourced materials.
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the
product. Chef'sChoice®, EdgeCraft®, Diamond Hone®, EdgeSelect® and the overall design of this product are
registered trademarks of the EdgeCraft Corporation.
Conforms to UL Std. 982
© The Legacy Companies 2021
H21
The Legacy Companies
Certified to CAN/CSA Std. C22.2 No. 64
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
En/Fr/Sp
English — 14
Figure 14. Removing cover under base to clean out
metal dust (see Normal Maintenance section).
chefschoice.com
C318204