Troubleshooting; Specifications; Common Service Parts - Briggs & Stratton 030722-00 Manual Del Usuario

Troubleshooting

Problem
Engine is running, but no
AC output is available.
Engine runs well at no-load
but "bogs down" when
loads are connected.
Engine will not start; starts
and runs rough or shuts
down when running.
For all other issues, see a Briggs & Stratton Authorized Dealer.

Specifications

Wattage* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6,900 Watts
Starting Watts** . . . . . . . . . . . . . . . . . . . . . . . 8,500 Watts
AC Voltage at 230 Volts . . . . . . . . . . . . . . . . . . . 30 Amps
Frequency. . . . . . . . . . . . . . . . . . . . . . . 50 Hz at 3000 rpm
Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Single Phase
Displacement . . . . . . . . . . . . . . . . . . 25.63 cu. in.(420 cc)
Spark Plug Gap . . . . . . . . . . . . . . . . . 0.030 in. (0.76 mm)
Fuel Capacity . . . . . . . . . . . 7.5 U.S. Gallons (28.4 Liters)
Oil Capacity . . . . . . . . . . . . . . . . . .36 Ounces (1.0 Liters)

Common Service Parts

Engine Oil Bottle . . . . . . . . . . . . . . .100005E or 100007E
Synthetic Oil Bottle . . . . . . . . . . . . . . . . . . . . . . 100007W
Fuel Stabilizer . . . . . . . . . . . . . . . . . . . 992380 or 992381
For a full list of parts and diagrams, please visit BRIGGSandSTRATTON.COM.
Power Ratings: The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE
J1995. Torque values are derived at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others;
horsepower values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net
power values are taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments.
Actual gross engine power will be higher than net engine power and is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Given the wide array of products on which engines are placed, the gasoline engine may
not develop the rated gross power when used in a given piece of power equipment. This difference is due to a variety of factors
including, but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.),
application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to engine variability. Due to
manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this engine.
* Generator per EN ISO 8528-13:2016, Reciprocating internal combustion engine driven alternating current generating sets -- Part 13: Safety.
** Per Briggs & Stratton 628K, Starting Watts represents the momentary electrical current the generator can provide to start electric
motors. Starting Watts does not represent the power required to continuously run electrical loads. Starting Watts is the maximum
current that can momentarily be supplied when starting a motor, multiplied by the generator's rated voltage.
Cause
1. One of the circuit breakers is open.
2. Poor connection or defective cord set.
3. Connected device is bad.
1. Generator is overloaded.
1. Start switch set to OFF (0) position.
2. Fuel valve is in OFF (0) position.
3. Low oil level.
4. Out of fuel.
5. Spark plug wire not connected to
spark plug.
6. Flooded with fuel.
7. Low battery charge.
Correction
1. Reset circuit breaker.
2. Check and repair.
3. Connect another device that is in
good condition.
1. Remove loads from generator.
1. Turn switch to RUN (I) position.
2. Turn fuel valve to ON (I) position.
3. Fill crankcase to proper level or
place generator on level surface.
4. Fill fuel tank.
5. Connect wire to spark plug.
6. Wait 5 minutes and re-crank engine.
7. Charge battery for 24 hours.
9