Putting Into Operation; Working Instructions - stayer RO150E Manual De Instrucciones

Keep your workplace clean. Material mixtures
are especially dangerous. Light metal dust can
burn or explode.
Do not use the machine with a damaged ca-
ble. If the cable is damaged while working, do
not touch the damaged cable but pull the
mains plug. A damaged cable increases the risk
of an electrical shock.
For machines used outdoors, connect to the
mains using a fault current (FI) protection
switch.
Use the electro-tool only for dry sanding. The
penetration of water into the electro-tool increases
the risk of an electrical shock.
Take care that no persons are endangered by
flying sparks. Remove combustible material
from the vicinity. When sanding metals, sparks
are produced.
Caution, fire hazard! Avoid overheating of the
sanded material and the electro-tool. Always
empty the dust container before pauses in the
work. For unfavourable conditions such as flying
sparks when sanding metals, sanding dust in the
dust bag, micro filter or paper sack (or in the filter
sack or filter of the wet/dry vacuum cleaner) can
self-ignite, especially when mixed with remainders
of varnish, polyurethane or other chemical materi-
als and when the sanded work piece is hot after
long periods of working.
Replacing the Sanding Sheet/
Sanding Plate
Before any work on the machine itself, pull the
mains plug.
Changing the Sanding Plate
Replace damaged sanding plates without delay.
To replace the sanding plate 7, pull off the sanding
sheet or polishing tool.
When placing on the sanding plate, take care
that the teeth of the drive piece engage in the re-
cesses of the sanding plate.
Changing the Sanding Sheet
Lift the sanding sheet 5 at the edge and pull it off the
sanding plate 7. Clean the sanding plate 7, if required.
Press the new sanding sheet 5 against the bottom of
the sanding plate. To ensure optimum dust extraction,
the holes of the sanding sheet must match with those
of the sanding plate.
ENGLISH
11
Dust/Chip Vacuuming
External Dust Extraction with a Vacuum
Cleaner
(Accessory pages)
Connect a vacuuming hose (accessory) directly to the
vacuuming adapter 3.
The vacuuming adapter 3 is made of
antistatic material. With the additional
use of an antistatic vacuuming hose
(accessory), the electrostatic charging
of the machine, which can occur while
sanding in rare cases, is prevented.
The vacuum cleaner must be suitable for the material
to be worked.
When vacuuming dry dust that is especially detrimen-
tal to health or carcinogenic, use a special vacuum
cleaner.

Putting into Operation

Switching On/Off
To switch on: Slide the on/off switch 2 forward and
press down until it latches.
To switch off: Press the on/off switch 2 down at the
rear until it springs to the off position.
Speed Selection
Preselect the required speed with the thumbwheel 1
(also while running).
The Constant Electronics maintain the preselected
speed nearly constant also under load.
The required speed is dependent on the material and
can be determined by practical trials (see Application
Table).
After longer periods of working at low speed, allow the
machine to cool by running for approx. 3 minutes at
maximum speed with no load.

Working Instructions

Wait until the machine comes to a standstill
before putting it down.
Before any work on the machine itself, pull the
mains plug.
11