Turbo-V 2300 Rack Controller Description - Agilent Technologies Turbo-V 2300 Manual De Instrucciones

Turbo-V 2300 Rack Controller Description

The controller is available in two versions:


The models are provided with a front panel with an LCD
alphanumeric display to indicate the operating
conditions/parameters of the Turbo-V pump and a keyboard, and a
rear panel with input/output connectors.
The following figure is a picture of the Turbo-V controllers. The
controller is a solid-state frequency converter which is driven by a
single chip microcomputer and is composed of:




The microcomputer generates the variable output frequency and
controls the 3-phase output voltage according to the software and the
gas load condition of the pump. Moreover, it manages signals from
sensors, input/output connection information to be displayed, and
gives outputs for a fully automatic operation. The heater jacket and
flow meter are also handled. An EEPROM internal to the
microprocessor is used to store pump operating parameters and the
input/output programmed information.
The controller can be operated via:



Turbo-V 2300 Rack Controller User Manual / 87-901-022-01 (B)
Model 9699539 (220 Vac, 50-60 Hz)
Model 9699540 (120 Vac, 50-60 Hz)
Power transformer
Front panel display and keyboard
Rear panel with input/output connectors
PCB including: power supply analog and input/output section,
microprocessor and digital section, display and keyboard
circuits. The power supply converts the single phase (50-60 Hz)
AC mains supply into a 3-phase, low voltage, medium frequency
output which is required to power the Turbo-V pump.
Front panel switches
Remote signals via rear panel connectors
RS 232 serial link
Technical Information

Turbo-V 2300 Rack Controller Description

17
207/262