Connection J10 - Controller To Pump Connection - Agilent Technologies Turbo-V 2300 Manual De Instrucciones

Connection J10 - Controller to Pump Connection

A five-meter long cable is provided to connect the controller to the
pump. The following figures show the controller output connector
configuration where pins:




Figure 15
Turbo-V 2300 Rack Controller User Manual / 87-901-022-01 (B)
A-F = upper bearing sensor
B-C-D = 64 Vac 3-phase output to pump motor stator
E = ground
A-G =lower bearing sensor
Controller-to-pump connector (applicable to model 9699539 and
9699540)
Technical Information
Interconnections
219/262
17