Kit Assembly - Metra 95-8210 Instrucciones De Instalación

1. Secure the radio brackets to the radio
trim panel using (4) #8 x 3/8" Phillips
screws supplied. (Figure A)
2. Slide the radio into the bracket/panel
assembly, then secure it using the
screws supplied with the radio. (Figure
B)
3. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
4. Secure the radio assembly to the dash
using the factory hardware.
Note: The top bar can be removed or left
on. (Figure C).
5. Reassemble the dash in reverse order of
disassembly to complete the installation.

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 5/8/2018 INST95-8210
3