Bremont ALT1-ZT Manual Del Usuario página 5

ALT1-Z/ALT1-ZT
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. With the chronograph you can measure up to 12 hours in
hours, seconds and minutes. It also shows the time in another time zone
using its 24 hour hand (or UTC hand). The mechanical movement with
automatic winding has a free-swinging rotor that keeps the mainspring
wound via the motion of your wrist. The movement in your ALT1-Z/ALT1-
ZT has 25 jewels, runs at 28,800 bph and has a 42-hour power reserve
once fully wound. The watch is water resistant to 100m (10ATM) and the
dial is protected by a dual anti-reflective sapphire crystal that is retained
securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your ALT1-Z/ALT1-ZT can be wound from crown position I by rotating
the crown in a clockwise motion. The movement will automatically start
with just a few revolutions of the rotor, however it is better to wind the
movement fully with 30-40 revolutions of the crown. By doing this you
will achieve maximum accuracy and have a power reserve of 42-hours,
even when the watch is not on your wrist.
SETTING THE dATE
You can adjust the date by pulling out the crown to position II. You will
now be able to change the date by rotating the crown anti-clockwise.
Do not change the date between 20:00 and 03:00
SETTING THE TIME
Pull the crown out to position III, this will stop the movement, you can
now position the minute hand exactly. To start the second hand, push the
crown back to position I. When setting the time, it is worth noting that
the date change always takes place at mid-night (00:00). If this change has
already taken place at 12:00 noon, you must move the hands forward by 12
hours. Ensure that the crown is pushed back in after setting the watch.
USING THE ROTO-CLICk® BEZEL
Your ALT1-Z/ALT1-ZT is fitted with an internally rotating Roto-Click® bezel
with minute calibration. The bezel can be moved, both in a clockwise and
anti-clockwise direction using the bezel crown positioned at 8 o' c lock. To
use the timing function, rotate the bezel until the red triangle marker is in
line with the minute hand, the elapsed time can now be measured and read
using the minute hand against the minute and hour markers on the dial ring.