Use Of The Machine - Garland RODENT 604 W Manual De Instrucciones

English

7. USE OF THE MACHINE

Use this machine only for its intended use. Using
this chainsaw for any other use is dangerous and can
cause damage to the user and / or the machine.
Cut only wood. Do not use the chainsaw for other,
unforeseen purposes. For example: do not use the
chainsaw to cut plastic materials, bricks, or building
materials other than wood. Using the chainsaw for
operations other than those intended can lead to
dangerous situations.
This chainsaw is not designed for forestry work (felling
in forests).
Stay away from the chainsaw chain when the engine
is running.
If you slip or lose your balance or fall, release the
throttle trigger immediately.
Do not rely solely on the safety features of this
machine.
Do not use this machine if you are fatigued, ill, have
taken medication, narcotics, or alcohol.
Do not expose this machine to rain or wet conditions.
Water entering this machine will increase the risk of
electric shock.
Do not use this machine at night, in fog, or with
reduced visibility that makes it difficult to see the work
area.
Lack of rest and fatigue can lead to accidents or
damage.
Limit the time of continuous use of this machine to
10 minutes and rest between 10 and 20 minutes
between each session.
Never leave this machine unattended. Do not allow
anyone to enter the work area. This work perimeter
must be 15 meters and it is a dangerous area.
Holding the machine firmly by the handle will reduce
the risk of kickback and increase your control over
the machine. Never use the chainsaw when you are
on a ladder, in a tree, or any other unstable location.
Be careful when cutting thin branches or bushes. Thin
branches can catch on the chain and be suddenly
thrown off hitting you and knocking you off balance.
If you are cutting a branch that is in tension, be aware
of the possible rebound of the branch when making
the cut. Check the condition of the tree to prevent dry
branches from falling and hitting you while you are
cutting.
Clean the work area and remove all obstacles that
could cause accidents. While cutting, do not let the
tip of the chainsaw touch any log or obstacle. Remove
the chainsaw from the wood with the chain still
running. When cutting, always rest the claw of the
chainsaw on the log.
Pay extra attention when cutting wood that splinters.
Splinters can be thrown in any direction. There is risk
of injury.
Never stand on the branch you are cutting.
Always keep the chain sharp. Sharpen it as explained
in this manual.
If you make multiple cuts without letting go of the
machine, always turn the chainsaw off between cuts.
36/84