Installing The Bar And Chain; Battery Charge - Garland RODENT 604 W Manual De Instrucciones

6. INSTRUCTIONS FOR
COMMISSIONING
6.1. UNPACKING AND MATERIALS LIST
This machine includes the following items that you will
find inside the box:
1. Chainsaw.
2. Battery (x2)
3. Charger.
4. Tools.
5. Manual.
6.2. ASSEMBLING

6.2.1 INSTALLING THE BAR AND CHAIN

The chainsaw chain has very sharp teeth. Always
wear protective gloves to avoid accidental cuts
Make sure the machine is unplugged before doing
any work on this machine.
Chain bar and chain are supplied separately. To install
them, follow these steps:
1. Unscrew the nuts of the rod cap (6) and remove it.
2. Insert the chain bar (3) by sliding it through the
guide until it stops with the first screw.
3. Place the chain around the drive sprocket and
continue to pass it through the chain bar following
the guide.
Before mounting the guide bar with the chain,
check the cutting direction of the teeth. The correct
position of the chain will have the cutting edges of the
teeth in the direction of rotation of the chain:
Cutting teeth direction
4. Replace the bar cover (6) making sure that the
tensioning screw matches the lower hole of the
chain bar (3)

6.3. BATTERY CHARGE

The supply voltage and current must comply with the
indications on the charger's nameplate.
Before using the battery for the first time, charge it for
at least 1 hour.
To charge the battery, plug the charger into the mains,
connect the cable to the battery connector and the
LED will light up. When the battery is fully charged the
LED will change from red to green. When the battery
is charged remove it from the charger. If you leave the
battery in the charger and it is charged, the charger
33/84
English