Audi Wallbox Manual Del Usuario página 32

Set the CT coil's parameters locally using
the Configuration Manager of the wallbox.
See chapter Configure the Audi Wallbox
plus and Audi Wallbox pro locally for more
information.
Note: Any different configuration than the
ones presented above is considered invalid
and causes an error state.
Ground Loss Mo-
nitor Enabled
Ground Loss Mo-
nitor Disabled
Group B: Scaling current
NOTE: If the wallbox does
not have a CT coil attached
(indicated by DIP-switch
setting of group A =
0000x), then the scaling
current is the maximum
static current of the
station.
32
Group A switches
1 2
N/A N/A N/A
N/A N/A N/A
NOTE: If the wallbox does
have a CT coil attached,
which is set by DIP-switch
group A, then the scaling
current is the maximum
facility current per phase.
Ground loss monitor configuration
DIP-switch 5, in group A configures the functio-
nality of the ground loss monitor. By default, this
feature is enabled from the factory.
NOTE: The wallbox will not detect a
ground connection if the ground loss mo-
nitoring functionality is disabled.
3 4 5
N/A 0
N/A 1
Illustration
NOTE: If the static max
current is set above the
station rating, an error
will be shown and the
wallbox will be inoperable.