To Lift The Product - Husqvarna FS 4600 G II Manual De Usuario

CAUTION:
function when the engine is at idle speed or
off. The lever for speed control must be in
the stop position.
1. Turn the ignition key to the "I" position.
2. Push the lever for cutting depth adjustment rearward
until the cutting blade is above the surface.
3. Put the lever for speed control into the stop position.
1657 - 001 - 08.09.2021
Only engage the freewheel
4. Pull out and turn the knob for rear axle freewheel
function to engage the freewheel function.
5. Hold the operation handles and push the product to
move it.
WARNING:
product on a slope while the freewheel is
engaged. The product can move away
from you and cause injury to bystanders.
6. When the product is moved, push down the knob for
rear axle freewheel function to disengage the
freewheel function.
7. Turn the ignition key to the "0" position to stop the
engine.

To lift the product

WARNING:
equipment has the correct dimension.
WARNING:
product. Make sure that the lifting eye is
correctly installed and not damaged.
Do not push the
Make sure that the lifting
Do not lift a damaged
45