To Replace The Fuel Filter - Husqvarna FS 4600 G II Manual De Usuario

2. Remove the oil refill plug.
3. Remove the oil drain plug for the gearbox (B) and let
the oil drain into the container.
4. Install the oil drain plug for the gearbox.
5. Fill new gearbox oil into the hole for the oil refill plug
with a manual oil pump.
6. Fill until you see that the gearbox oil level is correct.
The correct gearbox oil level is when the gearbox oil
comes out from the hole for the oil refill plug.
7. Install the oil refill plug.
To replace the oil in the rear axle
1. Put a container below the rear axle tank.
1657 - 001 - 08.09.2021
2. Remove the plug (A) from the rear axle tank.
3. Remove the oil drain plug for the rear axle tank and
let the oil drain into the container.
4. Install the oil drain plug for the rear axle tank.
5. Fill the rear axle tank with new oil. Refer to
check of the oil level in the rear axle on page 30 .

To replace the fuel filter

WARNING:
prevent skin irritation. Fuel can come from
the fuel filter and onto your skin.
A
To do a
Use protective gloves to
39