To Do A Check Of The Engine Oil Level - Husqvarna FS 4600 G II Manual De Usuario

3. Remove the radiator coolant lid (A).
4. If there is radiator coolant in the expansion tank (B),
the radiator coolant flows back into the radiator
coolant container.
a) Wait until the radiator coolant is back in the
radiator coolant container.
Note:
It is not possible to fully empty the
expansion tank. There is always some radiator
coolant in the expansion tank.
5. Examine the radiator coolant level in the radiator
coolant container. The radiator coolant level is
correct when the radiator coolant is immediately
above the heatsinks in the radiator coolant container.
6. If the radiator coolant level is low, fill until the radiator
coolant level is correct. Refer to
page 48 for the correct radiator coolant type and
mixture.

To do a check of the engine oil level

1. Remove the cutting blade. Refer to
cutting blade on page 17 .
2. Make sure that the product is level.
3. Stop the product. The engine oil flows back into the
oil tank.
4. If the product has been in operation or moved, wait
10 minutes until the engine oil is back.
30
B
A
Technical data on
To remove the
5. Remove the dipstick from the oil tank.
6. Clean the oil from the dipstick.
7. Put the dipstick back fully into the oil tank.
8. Remove the dipstick.
9. Examine the oil level on the dipstick. Make sure that
the level of engine oil is between the marks on the
dipstick.
10. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 48 for correct engine oil type.
To do a check of the oil level in the rear
axle
1. Make sure that the product is level when you
examine the oil level in the rear axle.
2. Put a container below the oil drain hole.
Technical data
1657 - 001 - 08.09.2021