Battery Maintenance; To Connect And Disconnect The Battery; To Replace The Air Filters - Husqvarna FS 4600 G II Manual De Usuario

2. Open the valve (A) on the engine.
3. Put a container below the valve on the radiator
coolant container.
4. Open the valve (B) on the radiator coolant container.
B D
5. Remove the radiator coolant lid (C). The radiator
coolant drains from the system.
6. Close the valve (D) on the radiator coolant container.
7. Close the valve (E) on the engine.
8. Fill with radiator coolant until the radiator coolant
level is correct. Refer to
radiator coolant level on page 29 .
9. Install the radiator coolant lid.

To replace the air filters

1. Clean the area around the air filter housing.
1657 - 001 - 08.09.2021
A
E
To do a check of the
2. Open the 2 clamps on the air filter housing and
remove the air filter housing.
3. Replace the outer air filter (A) and the inner air filter
(B).
4. Install the air filters and close the 2 clamps.
Note:
If the 2 clamps of the air filter housing
cannot be closed, the air filters are not correctly
installed.
C

Battery maintenance

Note:
The battery on your product is maintenance
free. Do not open or remove the caps or the covers.

To connect and disconnect the battery

1. Install the battery holder (A).
2. Connect the red battery cable to the POSITIVE (+)
battery terminal on the battery.
3. Connect the black battery cable to the NEGATIVE (-)
battery terminal on the battery.
4. Disconnect the battery cables in the opposite
sequence of how they were connected.
B
A
A
41