Menu System - Husqvarna FS 4600 G II Manual De Usuario

Menu system

Menu system overview
Main menu
Active Engine Fault Codes
Service Fault Codes
Stored Engine Fault Codes
Engine Parameters (View)
Operation Event Log
Engine Identification
Module Information
Controller Setup
Press up arrow key followed by enter key to enter
password. When password is entered press up arrow key.
Press up arrow key twice to continue without password.
Quick Setup
Module Configuration
Display Configuration
Maintenance Configuration
24
Submenus
View/Scroll Active Fault Codes
View/Scroll Service Fault Codes
View/Scroll Stored Fault Codes
Total Hours
Load at RPM
Engine Torque
Coolant Temp
Fuel Rate
Manifold Temperature
Potential Voltage
View Last 32 Events (Start, Stop, Alarms)
Engine Model # View
Engine Serial # View
Control Unit Part Number
Control Unit Software Version
CI-Station
Engine Type
Number of Starts
Total Operation Hours
(c) 2020 Controls Inc
Visit www.controlsinc.com
Quick Setup Engine
Engine Type
Engine Manufacturer
Module Configuration
Menu time out
Low Power Mode
Power Save Delay
Pre Alarm Display
Mode Primary
Check Run Creteria
Clear Po Log
Clear Number Of Starts
Engine Run > 400 RPM
Engine Stop < 50 RPM
Display Configuration
Pressure and Temperature Units (Default = English)
Maintenance Configuration
Schedule Reset
1657 - 001 - 08.09.2021