Commissioning - Daitsu CDV 57 Manual De Instrucciones

Wired Controller CDV 57
(2)Pull out the two-core twisted pair from the installation hole on wall, and then
pull this wire through the connecting hole at the rear side of soleplate of wired
controller.
(3)Stick the soleplate of wired controller on the wall and then use screw M4×25 to
fix the soleplate and installation hole on wall together.
(4)Connect the two-core twisted pair to wiring column H1 and H2 respectively
and then tighten up the screws.
(5)Bundle panel and soleplate of wired controller together and the installation is
completed.
3.1.5 Disassembly

3.2 Commissioning

3.2.1 Parameter Enquiry
Unit parameters can be checked in unit on or off status.
Fig. 3.9 Disassembly diagram of wired controller
14