Lcd Display Instruction - Daitsu CDV 57 Manual De Instrucciones

Wired Controller CDV 57

1.2 LCD Display Instruction

No. Displaying name
WATER interface
1
arrow
2 WATER ON/OFF
3 Standard hot water
4 Preset
5 Available hot water
6 Night
7 Sun-flower
8 Temperature Zone
9 Auto
10 Sterilize
11 Rapid
12 Clean
13 Absence
Table 1.1 LCD display instruction
The icon will light up when the current wired controller is at the
interface of hot water function.
Overview of the hot water function: the WATER icon keeps on; the
ON/OFF icon is displayed according to the on or off status of hot
water function.
Standard hot water mode
Preset hot water mode;
The proportion of available hot water for the current user is displayed
according to the state in the frame for available hot water; it is
displayed only at the interface for hot water;
Night hot water mode;
It is displayed when the SUN-FLOWER function is valid;
Set water temperature/actual water temperature is displayed.
It's displayed when the function of water temperature auto setting is
valid. This function can be set separately under water heating or floor
heating and the icon is displayed according to whether the function
under the respective interface is valid or not.
The icon will light up when the STERILIZE function is valid and will be
blinking under sterilization.
It's displayed when the RAPID function is valid. This function can be
set separately under water heating or floor heating and the icon is
displayed according to whether the function under the respective
interface is valid ornot.
The icon will light up when the CLEAN function is valid and will be
blinking under cleaning status.
It's displayed when the ABSENCE function is valid.
2
Instructions