Parameter Setting - Daitsu CDV 57 Manual De Instrucciones

Wired Controller CDV 57
View water
C21
temperature
Note:
Under parameter viewing status, "FUNCTION",TIMER","WATER/AC/FLOOR"
buttons are invalid. Press button "ON/OFF" or "ENTER/CANCEL" to go back to the
home page, but not turning on/off the unit.

3.2.2 Parameter Setting

Unit parameters can be set in unit On or Off status.
(1)Long-press "FUNCTION" button for 5s and the temperature zone displays
"C00"; continue long-pressing "FUNCTION" button for another 5s to enter the
interface of setting wired controller parameters. "P00" is displayed in
1.If user exits the "C18" interface manually, the one-button
viewing function will be immediately turned off.
2.If system exits the "C18" interface due to no action in 20
seconds, user has to press the "ON/OFF" button under
on/off status to cancel this function.
3.After the one-button viewing function is turned on,
pressing the "ON/OFF" button of any wired controller of the
same system network under on/off status will cancel this
function.
Operation method:
Enter viewing: press "MODE" button in "C21" status to enter
the interface of viewing water temperature. Press "▲" or
"▼" button to select the number of water tank or hot water
generator.
0～100℃
Display method:
Temperature zone: display project number of current water
tank or hot water generator;
Timer zone: display water temperature of water tank or hot
water generator.
18