Tabla de contenido
Publicidad
3 YEAR WARRANTY
This product is warranted against any faults in materials or manufacture for 3 years from the purchase
SPECIFIC INFORMATION
INSTRUCTIONS FOR USE – BLIN KIT
Summary
chart A.
The chart A describes the available versions in terms of length and type of connection. This product is intended for
use to protect and prevent against risks of falling from above in industry, in construction work, in rescue and, more
generally, for any application of work at a height. Various models and standard versions are available, shown in Tab.
A. Other special combinations of connectors and special lengths are available and the relative data are shown on
the product marking.
Use
, observing the rope direction marked on the device (
). After installing,
always conduct a locking test to verify the correct operation (
).
Always check the correct closure of the connectors [5][6][8].
Always connect to an attachment point for fall arrest (A) of an EN 361 full body harness. The use of a sternal
attachment point is preferable over a dorsal one. The connection must be exclusively as shown in
. Do not use
The connection lanyard [7] must never be detached from the fall arrest device [1]. The
a fall. Do not connect the device to the attachment points for suspension or for work positioning of an EN 813/ EN
358 harness. The anchor point must be preferentially located above the work area and must be in compliance with
the EN795 standard and/or known to have a resistance of 12 kN (metal anchors) or 18 kN (fabric anchors). Never
ascend above the anchor and avoid creating any slack on the rope (
). Use the rope supplied assembled with
the product only. If replacement is needed, use the spare ropes listed in chart A only. The replacement procedure is
shown in
. Fixing or tensioning the rope is not necessary but, to improve sliding, application of a light weight at
the bottom of the rope is useful (< 5 kg).
clearance distance, the user must take particular care because he may not be completely protected in the event of a
to prevent the device from accidentally coming out of the safety line. The maximum weight of the user, including the
chart
A
potential fall of the user (
). For the use of the Rope Surfer, accessory guide part to improve sliding, see
.
In case of an extended stay at the same work point, the device can be taken to a position higher than the operator
(
). If the safety line is used to suspend the operator, it becomes, for all intents and purposes, a work line and
therefore an additional safety line must be used for optimum safety of the worker. In the event of dynamic loads on
28
Publicidad
Tabla de contenido
