Bosch eShift Shimano Nexus Di2 Manual Original página 13

OBJ_BUCH-3117-001.book Page 5 Thursday, June 22, 2017 3:14 PM
eShift with NuVinci H|Sync
The optimum gear for the respective speed is automatically
set according to a pre-defined desired cadence. In manual
mode you can choose between multiple gears.
eShift with the Intuvia on-board computer
In the " NuVinci Cadence" mode you can use the "–" or
"+" button on the operating unit to increase or decrease the
desired cadence. If you hold down the "–" or "+" button, the
cadence will increase or decrease in steps of five. The desired
cadence is shown on the display.
In the " NuVinci Gear" mode you can use the "–" or "+"
button on the operating unit to switch back and forth between
several defined transmission ratios. The engaged transmis-
sion ratio (gear) is shown on the display.
Intuvia eShift basic settings menu
You can choose from the following additional basic settings:
– ...
– "Gear calibration": You can calibrate the continuously
variable transmission here. Confirm the calibration by
pressing the "Bike lights" button. Then follow the instruc-
tions.
In the event of an error, it can also be necessary to perform
calibration when riding. In this case, you also confirm the
calibration by pressing the "Bike lights" button and then
follow the instructions on the display.
This menu item is displayed only when the on-board
computer is in the holder.
– ...
eShift with the Nyon on-board computer
The optimum gear for the respective speed is automatically
set according to a pre-defined desired cadence. In manual
mode you can choose between multiple gears.
In the "Cadence Control" mode, you can use the "–" or "+"
button on the operating unit to increase or decrease the re-
quired cadence. If you hold down the "–" or "+" button, the
cadence will increase or decrease in increments of five. The
desired cadence is shown on the display.
Bosch eBike Systems
– "Gear vx.x.x.x": This is the software version of the
variable speed transmission. This menu item is displayed
only when the on-board computer is in the holder. This
menu item is only displayed in conjunction with an elec-
tronic variable speed transmission.
– ...
Intuvia eShift function displays
You can choose from the following additional functions in the
function display (combination of text display and value
display):
– ...
– " NuVinci Cadence/Gear": Pressing the "i" button for
more than 1 s takes you to the NuVinci menu item from any
menu item in the information menu.
To switch from the " NuVinci Cadence" operating mode
to the " NuVinci Gear" operating mode, press the "i"
button for 1 s.
Simply press the "i" button briefly to switch from the
" NuVinci Gear" operating mode to the
" NuVinci Cadence" operating mode.
The default setting is " NuVinci Cadence".
Range Odometer
(1 s)
– ...
In the "Gear Control" mode, you can use the "–" or "+"
button on the operating unit to switch back and forth between
several defined transmission ratios. The engaged gear is
shown on the display.
Under "Gear calibration", you can calibrate the continuously
variable transmission. Then follow the instructions on the
display.
In the event of an error, it can also be necessary to perform
calibration when riding. Confirm the calibration here too, and
follow the instructions on the display.
English–5
NuVinci Cadence
(1 s)
NuVinci Gear
0 275 007 XES | (22.6.17)