Bosch eShift Shimano Nexus Di2 Manual Original página 15

OBJ_BUCH-3117-001.book Page 7 Thursday, June 22, 2017 3:14 PM
eShift with SRAM DD3 Pulse
The hub gear of the SRAM DD3 Pulse works on a speed-
dependent basis. Regardless of which gear is engaged on the
eShift with the Intuvia on-board computer
The engaged gear will be shown briefly on the display when-
ever the gear of the gear hub is shifted.
If the eBike is brought to a stop from a speed of more than
10 km/h, the system may automatically shift down a gear to a
set "Start gear". The "Start gear" can be set in the basic set-
tings menu.
In the " Gear" mode you can use the "–" or "+" button on
the operating unit to switch back and forth between several
defined transmission ratios. The engaged transmission ratio
(gear) is shown on the display.
In the " Gear" manual mode, the system can also auto-
matically switch back to a set "Start gear".
The drive unit recognises the gear shift and briefly reduces
the motor assistance level as a result of it, which means the
gear can also be shifted at any time under load or on a hill.
Intuvia eShift basic settings menu
You can choose from the following additional basic settings:
– ...
– "– Start gear +": The starting gear can be set here. In the
"––" position, the automatic function for shifting down a
gear is switched off. This menu item is displayed only when
the on-board computer is in the holder.
– ...
– "Gear vx.x.x.x": This is the software version of the
variable speed transmission. This menu item is displayed
only when the on-board computer is in the holder. This
menu item is only displayed in conjunction with an elec-
tronic variable speed transmission.
– ...
eShift with the Nyon on-board computer
It is possible to use the "–" or "+" button to shift gear manu-
ally here. Automatic mode is activated automatically if you
press the "–" button in first gear. If you press the "–" or "+"
button in automatic mode, the mode changes back to manual
mode. In automatic mode, only "A" is ever shown in the gear
display. If the gear is shifted in automatic mode, the gear is
not shown on the display.
If you are not in automatic mode, the engaged gear will be
shown briefly on the display whenever the gear of the hub
gear is shifted.
Bosch eBike Systems
derailleur gears, one of the three gears of the gear hub will
automatically be engaged.
Intuvia eShift function displays
You can choose from the following additional functions in the
function display (combination of text display and value
display):
– ...
– " Automatic gear selection":
Range Odometer
(1 s)
By pressing the "i" button for more than 1 s, you can
switch back and forth between the " Gear: Auto" auto-
matic mode and the " Gear" manual mode.
If you are in first gear in manual mode, you can also press
the "–" button to go to the " Gear: Auto" mode. By
pressing the "–" button again, you can switch back to the
manual mode. It is also possible to access the manual
mode by pressing the "+" button.
– ...
The drive unit recognises the gear shift and briefly reduces
the motor assistance level as a result of it, which means the
gear can also be shifted at any time under load or on a hill.
If the eBike is brought to a stop from a speed of more than
10 km/h, the system may automatically shift down a gear to a
set "Start gear". The "Start gear" can be set under
"My eBike" > "eShift".
English–7
Gear: Auto
(1 s)
(1 s)
Gear
0 275 007 XES | (22.6.17)