Safety Checks; Disposal Of The Unit; Technical Data - Olympus CelonLab ENT Instrucciones De Uso

ENT
CelonLab
6.2 Repairs
If a defect occurs, Olympus Winter & Ibe GmbH or a contact appointed by
Olympus Winter & Ibe GmbH (e.g. distributor) must be informed. The repair
must only be carried out by Olympus Winter & Ibe GmbH or a firm authorised by
Olympus Winter & Ibe GmbH (ask the Olympus Winter & Ibe GmbH distributor
responsible for your area). Service documents such as circuit diagrams, parts
lists, equipment descriptions and setting instructions are available from the
manufacturer for technicians who are authorised to carry out maintenance and
repair.
Caution: When the housing is opened there is a danger of electric shock. The
unit must only be opened by authorised technicians.

6.3 Safety Checks

The unit must undergo a safety check at yearly intervals in accordance with the
national statutory regulations. For this purpose, Olympus Winter & Ibe GmbH or
a firm authorised by Olympus Winter & Ibe GmbH must be commissioned by the
operator.

6.4 Disposal of the Unit

When disposing of the product, or any of its components, follow all applicable
national and local laws and guidelines.
Waste Electrical and Electronic Equipment
In accordance with European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment, this symbol indicates that the product must
not be disposed of as unsorted municipal waste, but should be
collected separately.
Refer to your local Olympus distributor for return and/or collection systems
available in your country.

7. Technical Data

Unit designation
Outputs
Applied part
Rated output power
Power selection
Impedance dependency of the power
Rated output frequency
Max. peak output voltage
Max. peak output voltage as a function
of the power level
Audio-frequency of "generator active"
signal
Audio-frequency if impedance too low
10
EN
ENT
CelonLab power control unit
REF: WB991007 (100 ... 120 V~)
REF: WB991001 (200 ... 240 V~)
bipolar
Type BF, defibrillation-safe
25 W at 100 Ohm
From 1 to 25 W in 1 W steps
See information accompanying the unit
470 kHz
< 150 V
peak
See information accompanying the unit
300 Hz – 2.5 kHz (for impedance range
25 – 400 ohms)
300 Hz, pulsed with approx. 1 Hz
Instructions for Use
W7098046