Settings And Various Recommendations; Pedals; Wheel Axles - Moustache Lundi 27 Manual De Usario

4 | SETTINGS AND VARIOUS RECOMMENDATIONS

4.1 PEDALS

To install your pedals, you simply need to
follow these steps:
1. Put a small amount of mounting
grease (you can find this at your local
bike retailer) on the thread of each
pedal.
2. Tighten the right pedal (marked "R"
on the pedal, see Figure 13) in a clo-
ckwise direction on the crank on the
drive side.
3. Tighten the left pedal (marked "L" on
the pedal, see Figure 13) in an anti-clockwise direction on the crank on the left side.
4. The recommended torque rate is 30 Nm.
Figure 13. Marked "R" (Right) and "L" (Left)

4.2 WHEEL AXLES

This chapter includes explanations and information only for rapid release axles.
Information about other axle systems can be found in the Moustache technical
notice available on our website www.moustachebikes.com/en/manuals.
Important : if you wish to take the rear wheel off your bike, it is easier if you place
the chain on the smallest cog and the derailleur in disengaged/clutch position (if this
is possible). To disengage your derailleur, ask your retailer for advice or consult the
notice on your derailleur.
60
WARNING!
If you equip your Moustache with cli-
pless pedals, you should refer to the
user instructions supplied with them
in order to familiarize yourself with the
clipping and unclipping mechanism of
this type of pedal. There is a risk of falls
and injury.
FR EN GE
WARNING!
Wheel axles are essential safety elements on your bike. Please respect the information
below, otherwise you risk losing parts and falling. Never tighten the lever by pushing
against the brake disc!
A wheel badly tightened or badly centered can cause accidents and serious
injury to the user.
4.2.1 Quick release wheel axle
A quick release has been designed to be easily adjusted with your hand. Never use a tool to
block or release the mechanism in order not to damage it.
To fully understand the steps below, you need to know the names of the parts making up this
quick release axle:
3
4
Figure 14. Quick release wheel axle: 1 Shaft 2 Nut
4.2.2 Opening the quick release axle
If you want to remove the wheel of your Moustache, please follow this process:
1. Open the axle's lever. You should now be able to read the engraved "OPEN» on the
lever as in Figure 15.
2. Loosen the nut on the other side of the axle by hand until there is sufficient play that you
are able to remove the wheel (It is not necessary to remove the axle from the wheel hub).
3. Take off the wheel.
IT ES NL
CLOSE
Figure 15. Opening the quick release axle
FR EN DE
1 4
3 Lever 4 Conical spring
OPEN
IT ES NL
2
61