Product Description - 3M DBI-SALA 2200094 Manual De Instrucciones Para El Usuario

;
Prior to installation and use of this equipment, record the product identification information from the ID label in the
Inspection and Maintenance Log (Table 2) at the back of this manual.

PRODUCT DESCRIPTION:

Figure 1 illustrates the 3M™ DBI-SALA™ Vacuum Anchor. The Vacuum Anchor is a single point anchorage connector for a
personal fall arrest system designed to be temporarily attached to a smooth horizontal or vertical surface.
Figure 2 illustrates components of the Vacuum Anchor. See Table 1 for Component Specifications. The Vacuum Anchor is
comprised of two pads that form the Base (A) with a center support structure Housing (B) and a D-Ring for the attachment of a
Fall Arrest System (FAS). The Vacuum Anchor is secured in place by the connection of compressed air inserted through into the
compressed air fitting on the Housing.
System Specifications:
Capacity: 1 Person with a combined weight (clothing, tools, etc.) of no more than 140 kg (310 lb.).
Fall Arrest: The structure to which the Anchorage Connector is attached must sustain static loads
Anchorage:
applied in the directions permitted by the Fall Arrest System of at least: 12 kN (2700 lbf) with
certification of a Qualified Person
Each anchorage point location must be capable of the following values:
EN 795
OSHA 1926.502, 1910.140
Only one Fall Arrest System may be attached to an individual Vacuum Anchor at a time.
Dimensions: See Figure 1 for the dimensions of each Vacuum Anchor model.
Product Weight: See Figure 1 for the weight of each Vacuum Anchor model.
Standards: Vacuum Anchor models covered in these instruction are rated for use according to the following
standards only, as listed in the table below:
2200094, 2200095, 2200096,
2200107, 2200108, 2200109
2200110, 2200111, 2200125,
2200126, 2200127
Compressed Air All Vacuum Anchor models require 80-150 psi (550-1035 kPa). External compressed air or nitrogen
Requirements: sources should be filtered to 5 microns.
Application
Minimum Application Radius: 36 in (91 cm)
Radius:
Service Air: -20°F to 115°F (-29°C to 46°C)
Temperature: Surface: -20°F to 140°F (-29°C to 60°C)
Elevation: Contact 3M regarding usage of the Vacuum Anchor at working elevations over 3,000 ft (1,000 m) above
sea level.
Component Specifications:
Figure 2
Reference Component
A Base
B Housing
C D-Ring
D Vacuum Gauge
E Attach/Release Control Valve
F Vacuum Hose
G Compressed Air Connection
H Vacuum Hose for Secondary Hose
I Carrying Handle
J Vacuum Pad
K Pad Filter
1 Qualified Person:
An individual with a recognized degree or professional certificate, and extensive experience in Fall Protection. This individual must be capable
of design, analysis, evaluation, and specification in Fall Protection.
Table 1 – Specifications
; or 22.2 kN (5,000 lbf) without certification.
1
12 kN (2700 lbf)
OSHA 1926.502
OSHA 1910.140
EN795:2012
Materials
Elastomer
Aluminum
Stainless Steel
ABS
Aluminum
Stainless Steel
Stainless Steel
Stainless Steel
Nylon
Rubber
White Felt
7
Note: