Changeable Security-Relevant Settings; Transport; Disposal - Dräger Polytron 6100 EC WL Instrucciones De Uso

3. Keep the magnetic pen on the marking for 5 to 10 seconds (LED stops
flashing) and then take it off.
✓ The gas detector restarts and is reset.
13.3

Changeable security-relevant settings

PolySoft Factory setting
SIL status off
000000
®
Bluetooth pairing PIN
Sample gas sensor-specific
Sample gas module sensor-specific
Measuring range sensor-specific
Upper capture value limit sensor-specific
Lower capture value limit sensor-specific
Test gas sensor-specific
Test gas unit sensor-specific
Test gas concentration sensor-specific
Calibration interval sensor-specific
A1 alarm sensor-specific
A2 alarm sensor-specific
Capture value sensor-specific
Sample gas LEL factor sensor-specific
PROFIsafe Watchdog Timeout 60,000
PROFIsafe Address F-Host 1
PROFIsafe Address F-Device 1
PROFIsafe Data Format float
Instructions for use |
Dräger Polytron
®
6100 EC WL, Dräger Polytron
PolySoft Factory setting
ISA 100 Provisioning Over the Air
ISA 100 Tag Name Serial number of the device
ISA 100 Network ID 0
14

Transport

The gas detector contains lithium batteries. During transport, especially when
transporting the gas detector by air, observe the relevant safety regulations and
the marking for lithium batteries.
15

Disposal

This product must not be disposed of as municipal waste. It is therefore
marked with the adjacent symbol. Dräger will take back this product for
free. For information please contact the national marketing organiza-
tions or Dräger.
Batteries must not be disposed of as household waste. They are there-
fore marked with the adjacent symbol. Dispose of batteries and
rechargeable batteries at battery collection points and in accordance
with current regulations.
Disposal of electrochemical sensors
WARNING
Danger of explosions and risk of chemical burns!
Sensor fluids may leak out and can cause acid burns.
► Do not dispose sensors in fire
► Do not open with force
®
Repeater ISA
| en
Transport
51