Dräger Polytron 6100 EC WL Instrucciones De Uso página 45

Quality Substatus
Bits 6 and 7 Bits 2 to 4
0 2
0 3
0 4
0 5
0 6
0 7
1 0
1 1
Instructions for use |
Dräger Polytron
PV Cause
NaN
Gas detector not connected to ISA100 Wireless
network (used by System Manager). Possible
causes:
– ISA100 Wireless
– ISA100 Wireless
NaN Serious device fault, various causes.
NaN Sensor not detected or defective.
NaN No communication with gas detector.
NaN No communication with gas detector.
NaN Warm-up phase 1 active.
Maintenance mode active.
Gas reading – (Bit not used)
Gas reading – (Bit not used)
®
6100 EC WL, Dräger Polytron
Remedy
™
A Check ISA100 Wireless
B Check ISA100 Wireless
C Check data for integration in
™
network can not be found
™
network settings changed
A Restart the gas detector.
B Reset the gas detector to factory settings.
C Update firmware.
D Have the gas detector checked by DrägerSer-
A Check the sensor connection.
B Remove and reinstall the sensor.
C Change the sensor.
A Check ISA100 Wireless
B Check ISA100 Wireless
C Check data for integration in
A Check ISA100 Wireless
B Check ISA100 Wireless
C Check data for integration in
Wait for warm-up phase 1 to finish.
Exit maintenance mode.
–
–
®
Repeater ISA
Troubleshooting
™
receipt.
™
network settings.
™
ISA100 Wireless
network.
vice.
™
receipt.
™
network settings.
™
ISA100 Wireless
network.
™
receipt.
™
network settings.
™
ISA100 Wireless
network.
| en
45