Atos Medical PROVOX Micron HME Manual página 13

All manuals and user guides at all-guides.com
Replacement of the Adhesive base plate
The Adhesive base plate can stay in place as long as it is glued properly
to the skin. To facilitate removal of partially attached Adhesives, the use
of adhesive remover, e.g. Remove™ may be helpful. After Remove™ is
used the skin should always be cleaned with a cleaning towel or soap
and water. Read instructions. Before applying a new Adhesive base
plate, the skin should be carefully cleaned and dried.
CAUTION: When cleaning the skin from residual glue, prevent
particles/fluids from entering the stoma. In case of using OptiDerm
in the postoperative period or sensitive skin, the Adhesive should
only be replaced when completely loose.
Storage
Store in a clean, dry and dark area at room temperature (15°C–25-
°C/60F–80F).
Provox® LaryButton™
Soft silicone laryngectomy stoma buttons (fig 1d).
- with or without using Provox LaryClip or Provox TubeHolder.
Read separate instructions.
Provox® LaryTube™
Soft silicone laryngectomy tubes (fig 1e).
- with or without using Provox LaryClip or Provox TubeHolder.
Read separate instructions.
13