aquatermic inverter Manual Del Usuario página 12

Operation Instructions
"Cancel" key
4. When the setting is saved, the control then will back to the FUNCTION page and the cursor
will be where the "Quiet timer" option is, then by the Up/Down key
or "Off".
[Notes]
① Once it is activated, it should be deactivated manually.
② This setting will be memorized upon power failure.
③ The saved "Start time" and "End time" will be memorized upon power failure.
④ It is configurable no matter if the unit is in operation or not.
2.2.9 Weather-dependent Mode
For areas with large change of diurnal temperature, in order to avoid the user to set the leaving
water temperature or room temperature too often, this function will adjust automatically depending on
the environmental temperature.
[Operation Instructions]
Go to the FUNCTION page and locate Weatherdepend, then, configure it through the Up/Down
key , "On" or "Off".
[Notes]
① Once it is activated, it should be deactivated manually.
② This setting will be memorized upon power failure.
③ At the "Parameter View" page, it is able to check the set point at the Weather-dependent
Mode.
④ When it is activated, it is allowed to set the room temperature but the set point does not take
effective. However, when it is deactivated, the unit will run according to this set point.
⑤ It can be set to "On" or "Off" no matter if the unit is in operation or not, but be activated only
when the unit is in operation.
⑥ This mode works only for the air conditioning function.
2.2.10 Holiday Release
In summer or high-temperature season, this function will make the unit pause to run in some
specific periods when the user is out.
[Operation Instructions]
Go to the FUNCTION page and locate "Holiday release", then, configure it through the Up/
Down key
to not save this setting.
, "On" or "Off".
9
, it can be set to be "On"