Parameter Setting (Parameter Set) - aquatermic inverter Manual Del Usuario

to set the address.
[Notes]
① It indicates the address of the control and is intended for the group control.
② It will not be memorized upon power failure.
③ The address range is [0,125] and [127,253]
④ The default address is 1 for the initial use.
2.2.35 Gate-Controller
It can be configured to be "On" or "Off" based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate "Gate-Controller", then, configure it through the Up/
Down key , "On" or "Off".
[Notes]
① When it is activated, the control will check the card is inserted or not. If inserted, the control
will run normally; if not, the control will turn off the unit and back to the homepage. In this case, any
key operation is ineffective (except for the combined key operation), or a dialogue box will pop up,
warning"Keycard uninserted!".
② It will not be memorized upon power failure.

2.3 Parameter Setting (Parameter Set)

2.3.1 User Parameter Setting
At the parameter setting pages, each parameter is configurable, like: water out temperature for
cooling, water out temperature for heating, and water tank temperature etc.
[Operation Instructions]
1. At the homepage, it is able to go to the PARAMETER page by pressing the Function key no.2
.
2. At the Parameter Set page, by the Left/Right key
then by the Up/Down key
changed when pressing and holding the key.
3. When the setting is finished, press "Save"
settings?". If so, press the OK key
[Notes]
increase or decrease the setting value which will be continuously
and a dialog box will pop up, reminding "Save
; if not press the Cancel key
22
Operation Instructions
select the desired option and
to not save this setting.