Water Tank - aquatermic inverter Manual Del Usuario

[Notes]
●It will be memorized upon power failure.
2.2.25 Solar antifre
When the solar system has been installed, it is highly suggested to activate this function.
[Operation Instructions]
Go to the FUNCTION page and locate "Solar antifre" then, configure it through the Up/Down
key , "On" or "Off".
[Notes]
●It will be memorized upon power failure.

2.2.26 Water Tank

It can be configured to be "With" or "Without" based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate "Water tank" then, configure it through the Up/Down key
, "With" or "Without".
[Notes]
① It will be memorized upon power failure.
② This setting is allowed only when the unit is turned off.
2.2.27 Tank Sensor
When the water tank has been installed, one group or two groups of tank sensors can be
selected to detect and control the water tank temperature.
[Operation Instructions]
Go to the FUNCTION page and locate "Water tank", then, configure it through the Up/Down key
, "1" or "2". When the water tank is unavailable, this option will be reserved.
[Notes]
●It will be memorized upon power failure.
2.2.28 Solar Heater
It can be configured to be "With" or "Without" based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate "Solar heater", then, configure it through the Up/Down
key , "With" or "Without".
[Notes]
●It will be memorized upon power failure.
2.2.29 Floor config
It can be configured to be "With" or "Without" based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate "Floor config", then, configure it through the Up/Down
key , "With" or "Without".
[Notes]
20
Operation Instructions