General Setting - aquatermic inverter Manual Del Usuario

2.4.4 Version View (VERSION)
At the version view page, the user is enabled to see the version of the program and the protocol.
[Operation Instructions]
1. At the VIEW page, select Version and then press the OK key
page.
2. At the VERSION page, the program and protocol versions are listed.

2.5 General Setting

At the general setting pages, the user is enabled to configure general parameters, like
temperature unit, language, On/off memory, time & date etc.
[Operation Instructions]
At the homepage, by pressing "GEN."
able to set "Temp. unit", "Language", "On/off memory", "Time & Date", "Beeper" and "Back light",
as shown in the figure below.
access to the GENERAL SET page. At this page, it is
30
Operation Instructions
to go to the VERSION