Function Setting - aquatermic inverter Manual Del Usuario

2.2 Function Setting

It enables the user to set each function.
[Operation Instructions]
1. At the homepage, by pressing the Function key no. 1
FUNCTION page 1, as shown in the figure below.
2. At the FUNCTION page, by the Right/Left key
be selected, and by the Up/Down key
modified. The function key no. 3
is finished, by pressing the Menu key
Return key the control will back to the higher level menu.
[Notes]
① Move the cursor to the desired option and "Enter" will be displayed at the lower left side of the
LCD, reminding you that you are allowed to access to the submenu by pressing the OK key
② At the FUNCTION page, when the setting of some function option is changed and needs to
be memorized, then in case of power failure it will be saved automatically and resume upon power
recovery.
FUNCTION page 1
, the setting of the current function option can be
or no. 4 can be used for switch pages. After the setting
, the control will back to the homepage, or by pressing the
4
Operation Instructions
, the control will access to the
, the desired function option can
.