aquatermic inverter Manual Del Usuario página 15

4. When above settings are finished, pressing the Return key and then pressing "Save", a pop-
up window will pop up to remind if you are determined to save these settings. If so, press the OK key
. If not, press the Return key
5. In this case, finally by pressing the Up key
[Notes]
① Totally five periods are allowed to be set for each time. For each period, "Start time" must be
earlier than "End time". Similarly, the preceding period must be earlier than its following period.
② When "Weekly timer" has been set successfully, by changing "FCU", "Water tank", "Ctrl
state", or "T-water ctrl", then the temperature set point for "Weekly timer" will be automatically
changed to the set point of last setting. For instance, if "Heat" is set for Monday of "Weekly timer",
"FCU" is set to "With" and the "T-water out" is 20 , by resetting "FCU" to "Without", then "T-water
out" will be the value of last setting. In this case, if FCU is disabled for last setting, then "T-water out"
to not save these settings.
, "Weekly timer" will be activated.
12
Operation Instructions