Parameter View (Para View) - aquatermic inverter Manual Del Usuario

2. At the STATUS page, it is able to check the status of each component.
Full Name
Compressor running state
Fan 1 running state
Fan 2 running state
Heat pump-water pump
Solar water pump running state
Swimming pool-water pump
Tank heater running state
3-Way valve 1 running state
3-Way valve 2 running state
Crankcase heater running state
Chassis heater running state
Plate heat exchanger heater
Defrost
Oil return
Thermostat
Assistant heater running state
Circulating two-way valve 1 running state
Circulating two-way valve 2 running state
Doorguard
Opration LED
Error LED
4-way valve running state
Enthalpy-enhancing solenoid valve
Heat pump-auxiliary heater 1
Heat pump-auxiliary heater 2
Solar kit- freeze protection
Heat pump-freeze protection

2.4.2 Parameter View (Para View)

At the parameter view pages, the unit is enabled to view the units' running parameters, like
outdoor temperature, suction temperature, discharge temperature, water in temperature, water out
temperature etc.
[Operation Instructions]
1. At the VIEW page, select Parameter and then press the OK key
page.
Viewable Components
Displayed Name
Compressor
Fan 1
Fan 2
HP-pump
SL-pump
Swimming-pump
Tank heater
3-way valve 1
3-way valve 2
Crankc.heater
Chassis heater
Plate heater
Defrost
Oil return
Thermostat
Assist. Heater
2-way valve 1
2-way valve 2
Doorguard
Opration LED
Error LED
4-way valve
En.valve
HP-heater 1
HP-heater 2
SL-Antifree
HP-Antifree
26
Operation Instructions
Status
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
Off/Cool/Heat
On/Off
On/Off
On/Off
Card in/Card out
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
Enabled/Disabled
Enabled/Disabled
to go to the Para View