Ec Declaration Of Conformity - Mettler Toledo InFit 76 Serie Guía De Configuración Rápida

13
6 Maintenance
1. Isolate the pipe / tank / vessel etc. from the housing (depressurize, empty, rinse, purge and vent, etc.).
2. Remove the sensor from the housing.
3. Remove the stationary housing from the pipe / tank / vessel etc. (if changing of housing seal is needed).
Note: Perform step #3 followed by #2 for InFit 762 / 763.
h
4. Change the housing seal.
5. Calibrate / clean the electrode / sensor with reference to sensor and transmitter instruction manuals.
6. Follow the installation and commissioning procedure.
7 Disposal
It is the user's responsibility to dispose of the housing in a professional manner and in accordance with local regulations.
8 Warranty
On manufacturing defects, 12 months after delivery.
9 Storage Condition
We recommended following the shutdown procedure as described in the housing instruction manual. The cleaned and
dried housing should be stored at room temperature.

10 EC Declaration of Conformity

The complete declaration is available in the declaration of conformity certificate.
InFit is a registered trademark of the METTLER TOLEDO Group in Switzerland, the USA, the European Union and a further
five countries.
© 06 / 20 METTLER TOLEDO
Printed in Germany
en
InFit 76X Stationary Housings
30 313 392 B