Cleaning The Electrodes; Troubleshooting - Kärcher FLEX S 36 M Manual Del Usuario

Cleaning the electrodes

! Release and remove the suction basket.
! Clean the electrodes.
! Insert and lock the suction basket.

Troubleshooting

Note
In case of a failure (e.g. fracture of the filter)
the appliance must be turned off immediate-
ly. The failure must be remedied before the
appliance is put into operation again.
Suction turbine does not run
! Check cables, plugs, fuse, and socket.
! Turn on the appliance.
Suction turbine turns off
! Empty the container.
Suction turbine does not start again after
the container has been emptied
! Turn off the appliance and wait for 5 se-
conds, turn it on again after 5 seconds.
! Clean the electrodes as well as the spa-
ce between the electrodes.
Suction capacity decreases
! Remove choking of suction nozzle, suc-
tion tube, "filter free" handle, suction ho-
se, or flat folded filter.
! Exchange the paper filter bag.
! Filter dedusting: Repeatedly press "filter
free" on the handle.
18 English
! Ensure the filter cover properly locks into
place.
! Exchange the flat folded filter.
Dust comes out during the vacuuming
! Check the proper installation of the flat
folded filter.
! Exchange the flat folded filter.
Automatic turn-off (wet vacuum cle-
aning) does not react
! Clean the electrodes as well as the spa-
ce between the electrodes.
! Continuously check the filling level in
case of non-conductive liquid.
"Filter free" is triggered permanently
! Release the blocked suction nozzle or
end of the hose.
! Stop the continuous vacuuming from the
liquid container or deactivate the "filter
free" function (see Wet vacuum cle-
aning).
! Remove choking of suction nozzle, suc-
tion tube, "filter free" handle, suction ho-
se, or flat folded filter.
! Exchange the flat folded filter.