Connecting Throttle Cable And Stop Switch Wires - Maruyama B43 Manual Del Propietario U Operador

CONNECTING THROTTLE CABLE AND STOP SWITCH
WIRES
1. Insert the throttle cable through the cable adjuster sleeve.
2. Position the slotted fitting on the carburetor so the recessed hole for the
lug is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable through the
slot in the slotted fitting, making sure the cable lug drops into the recessed
hole.
4. Operate the throttle trigger a few times to make sure that it works correctly.
5. Adjust the cable adjuster sleeve so the stop on the carburetor throttole
cam just contacts the throttle stop and the cable position keep 1-2mm play
between cable lug and slotted fittings when the throttle trigger is fully
depressed.
6. When the throttle cable is adjusted correctly, tighten the lock-nut.
7. Plug the stop switch wires into the matching connectors from the engine.
Note that wire polarity is not important.
8. Lap and fix the stop switch wires and connectors with clamp.
[BF43R, BF50R]
Clamp the throttle cable assembly with two bands as shown.
[B43, B43R, B50R]
Lap and fix the throttle cable assembly with the pad as shown.
[BF43R, BF50R]
Caution! : This swivel stopper is exclusively for fixing the handle in transport.
Do not engage the swivel stopper while operating the brushcutter.
In transport and strage:
Loosen the wing nut, place the stopper on A position of the bracket. Tighten
the wing nut, confirm the handle is fixed by the swivel stopper.
In operation:
Before start operation of the brushcutter, disengage the swivel stopper.
Loosen the wing nut, place the stopper at B position. Tighten the wing nut to
fix there, confirm the handle becomes free to turn around.
All manuals and user guides at all-guides.com
— US-3 —
Cable Adjuster Sleeve
Throttle Cable
Housing Lock nut
Throttle Cable
Cable Lug
Carburetor
Bracket
Slotted fitting Recessed
Hole
Matching connector
1-2mm Play
Stop Switch Wires
Clamp
Throttle Cable
Assembly
Band (2)
【 BF43R, BF50R 】
Pad
Throttle Cable
Assy
【 B43, B43R, B50R 】
Bracket
"A" Position
Swivel
Stopper
"B" Position
Wing Nut
【 BF43R, BF50R 】