Instruction Of The Throttle Trigger - Maruyama BT230L Manual Del Propietario U Operador

Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy
or full of bubbles.)
2. Move the choke lever to the open (
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (US-15).
If the engine fails to start after you follow the
above procedu res, contact an author ized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle lever.
2. Push the stop switch of the throttle trigger until
the engine will stop.
Stop Switch

Instruction of the throttle trigger

Start the blade rotation
1. Grasp the throttle lever.
2. Move the control lever to high speed side slowly.
3. Then engine speed increase gradually, and the
blade starts rotation.
) position .
4. Adjust the blade rotational speed by the control
lever.
Note: Engine speed does not increase by grasping
the throttle lever If the control lever is positioned
at low speed side fully.
Stop the blade rotation
1. The engine speed will down to idling by moving
the control lever to low speed position fully, or
releasing the throttle lever.
2. If you did not change the control lever position,
engine speed become to the original adjusted
speed when grasp the throttle lever again.
— US-16 —
L:
Low speed
H:
High speed
Blade Rotate
Blade Stop
Control Lever
Throttle Lever