Optional Colour Print Head With Replaceable Ink Cartridge - Olivetti JP 90 Manual Del Usuario

All manuals and user guides at all-guides.com
•
Still holding the print head with the nozzles downwards,
insert a new ink cartridge.
•
Make sure the ink cartridge is completely inserted.
•
Press the knob on the top of the cartridge to empty the ink
into the print head.
•
Check that the ink cartridge is empty, by controlling the ink
level indicator on the side of the print head.
THE INK CARTRIDGE MUST REMAIN INSERTED IN
THE PRINT HEAD.
•
Reinsert the print head in the printer ( see the specific
paragraph in "Quick Start" ).
•
Close the front cover
•
Press CARTRIDGE to return the print head to its rest
position, before starting a printing operation.
Do not reload the print head with more than one ink
cartridge at a time.
Make sure the print head is inserted and fixed correctly. If
necessary, repeat the insertion operation.
Do NOT push in the print head horizontally; if presented
correctly for insertion, it only needs to be pushed down
gently into place.
If you have problems inserting the print head:
•
Make sure the print head carriage is in the head loading
position (slightly to the right of the centre of the carriage
shaft).
14
•
Check that the print head housing is clean and free of
foreign bodies.
•
NEVER force the print head into the housing.
If you have problems when inserting the print head,
always remove it completely and repeat the entire
insertion operation.
Optional colour print head with replaceable ink
cartridge
Your printer can use a specific three-colour print head,
available in an optional colour kit which also contains a
colour printer driver on diskette, a storage box (item 5 on
page IV) for whichever print head you are not currently using
and installation instructions.
The colour print head has a replaceable cartridge which you
must change when one or more of the coloured inks runs
out. After you have substituted the ink cartridge several
times, you should replace the entire print head with a new
one (see the sequences of figures on pages VIII and IX).
To insert the colour print head, proceed as follows:
•
Open the sealed print head container and remove the print
head, holding it by the casing.
•
Remove the protective film.
Do not touch the electrical contacts or the printing
nozzles nor sit the print head on either of them.
•
Make sure there is paper in the ASF.
User Guide - Ink Jet Print Head