Snapper ESXDST82 Manual Del Usuario página 9

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
To REMoVE bATTERY PAcK
See Figure 5.
„ Release the switch trigger and lock-out
trigger to stop the trimmer.
„ Press the power button to turn off the
trimmer.
„ Press and hold the battery latch button (a)
on the back of the battery pack.
„ While holding the battery latch place one
hand the the trimmer handle and remove
battery pack.
STARTING/SToPPING THE TRIMMER
See Figure 6.
To start:
„ Press the on/off power button.
„ Depress the lock-out button and squeeze
the switch trigger.
„ Press high speed button to increase speed
depending upon grass condition. Two
LED's will illuminate above the high speed
button indicating that the trimmer is in the
high speed setting.
To stop:
„ Release the switch trigger.
„ Press the power button again to turn the
unit off.
NoTE: The unit will power itself down after
being idle for 1 minute.
oPERATING THE TRIMMER See Figure 7.
Follow these tips when using the trimmer:
„ Hold the trimmer with your right hand on
the rear handle and your left hand on the
front handle.
„ Keep a firm grip with both hands while in
operation.
„ Trimmer should be held at a comfortable
position with the rear handle about hip
height.
English (original instructions)
„ Cut tall grass from the top down. This will
prevent grass from wrapping around the
shaft housing and string head which may
cause damage from overheating.
If grass becomes wrapped around the string
head:
„ Remove the battery pack from the trimmer.
„ Remove the grass.
Contact with the trimmer cutting head while
operating can result in serious personal
injury.
ADVANcING LINE See Figure 8.
While the string trimmer is operating, the
cutting line gets worn down and becomes
shorter. This trimmer is equipped with bump
feed line advancement, which advances
additional line once the head is bumped on
the ground while rotating. The cutting blade
will cut the line to keep an accurate cutting
swath.
cUTTING TIPS See Figure 9.
„ Keep the trimmer tilted toward the area
being cut; this is the best cutting area.
„ The trimmer will cut better when moved
from left to right across the area to be cut;
it is less effective when moved from right
to left.
„ Use the tip of the cutting line to do the
cutting; do not force cutting head into uncut
grass.
„ Wire and picket fences cause extra cutting
line wear, even breakage. Stone and brick
walls, curbs, and wood may wear cutting
line rapidly.
„ Avoid trees and shrubs. Tree bark, wood
moldings, siding, and fence posts can
easily be damaged by the cutting line.
6
wARNING