Cutting Wheels; Composite Resin Cutting Wheels - Stihl TS 410 Manual De Instrucciones

English
1
2
Always make severing cuts so that
N
the abrasive wheel is not pinched.
Use wedges and/or leave ridges
N
that are broken after cutting.
4
3
If the severed part remains in the
N
recess after cutting (due to wedges,
ridges used), do not make any
further cuts – break the severed
part.
20

Cutting wheels

Cutting wheels are exposed to
extremely high loads especially during
hand-held cutting.
Only use abrasive whhels that comply
with ANSI B 7.1 for hand-held machines
and are correspondingly labeled. Note
that the maximum permissible speed of
the cutting wheel must be higher than
the maximum spindle speed listed on
the wheel guard label.
The cutting wheels that have been
developed for STIHL by well-known
manufacturers of abrasive wheels are of
high quality and tailored precisely to the
respective intended use as well as the
engine performance of the cut-off
machine.
Transport and storage
Do not expose cutting wheels to
–
direct sunshine or other thermal
stresses during transport and
storage.
Avoid jolting and impacts.
–
Stack cutting wheels flat on a level
–
surface in the original packaging in
a dry place where the temperature
is as constant as possible.
Do not store cutting wheels in the
–
vicinity of aggressive fluids.
Store cutting wheels in a frost-free
–
place.
Composite resin cutting
wheels
Types:
for dry applications
–
for wet applications
–
Economic benefit is improved and
premature wear can be avoided by
choosing and using the correct
composite resin cutting wheel. The short
name (e.g. "asphalt", "concrete")
on the label and
–
on the packaging (table with
–
recommended uses)
can help to ensure the correct choice.
STIHL composite resin cutting wheels
are suitable, depending on the version,
for cutting the following materials:
Asphalt
–
Concrete
–
Stone
–
Ductile cast pipes
–
Steel; STIHL composite resin
–
cutting wheels cannot be used to cut
railway tracks.
Do not cut any other materials – risk of
accident!
TS 410, TS 420