Stihl TS 410 Manual De Instrucciones página 9

By vehicle: Properly secure your cut-off
machine to prevent turnover, fuel
spillage and damage to the cut-off
machine. Never transport with cutting
wheel mounted. A wheel damaged
during transportation may shatter during
operation and cause serious personal
injury.
Fuel
Your STIHL power tool uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" of your instruction
manual.)
WARNING
Gasoline is an extremely
flammable fuel. If spilled
and ignited by a spark or
other ignition source, it
can cause fire and seri-
ous burn injury or
property damage. Use
extreme caution when
handling gasoline or fuel
mix. Do not smoke or
bring any fire or flame
near the fuel or the power
tool. Note that combusti-
ble fuel vapor may
escape from the fuel
system.
WARNING
Dust may collect on the powerhead,
especially around the carburetor, and
may absorb gasoline resulting in a risk of
fire. Clean dust from the powerhead
regularly.
TS 410, TS 420
Fueling Instructions
WARNING
Fuel your power tool in well-ventilated
areas, outdoors. Always shut off the
engine and allow it to cool before
refueling. Gasoline vapor pressure may
build up inside the fuel tank depending
on the fuel used, the weather conditions
and the tank venting system.
In order to reduce the risk of burns and
other personal injury from escaping gas
vapor and fumes, remove the fuel filler
cap on your power tool carefully so as to
allow any pressure build-up in the tank
to release slowly. Never remove the fuel
filler cap while the engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Wipe off
any spilled fuel before starting your
machine.
WARNING
Check for fuel leakage
while refueling and during
operation. If fuel leakage
is found, do not start or
run the engine until the
leak is fixed and any
spilled fuel has been
wiped away. Take care
not to get fuel on your
clothing. If this happens,
change your clothing
immediately.
WARNING
If fuel gets spilled on clothes, especially
trousers, it is very important to change
clothes immediately. Do not rely upon
evaporation. Flammable quantities of
fuel may remain on clothes after a spill
for longer than expected. Cutting metal
with a cut-off machine when clothes are
wet or damp from gasoline is extremely
dangerous, as the operator's clothes
might catch fire and cause serious or
fatal injury.
WARNING
An improperly tightened fuel cap can
loosen or come off and spill quantities of
fuel.
Different cut-off machines may be
equipped with different fuel filler caps:
Bayonet Fuel Filler Cap
Never use a tool to open or close the
bayonet fuel filler cap, as this could
damage the cap and cause fuel to leak
out.
The bayonet fuel filler cap must be
securely closed after refuelling.
English
7