Stihl TS 410 Manual De Instrucciones página 30

English
Inboard mounting
Disassemble the cutting wheel (see
N
"Fitting / replacing an cutting wheel")
Remove water attachment
N
Remove the adjusting lever
N
Slacken the V-belt
N
Remove the V-belt guard
N
Remove the "cast arm with guard"
N
Preparing the "cast arm with guard" for
inboard mounting
1 2
Unscrew the screw (1) of the limit
N
stop (2)
Remove the limit stop (2)
N
3
1 2
Turn the "cast arm with guard" so
N
that the guard is on the inboard side
Insert limit stop (2) – align the hole
N
in the limit stop with the hole in the
cast arm
28
Screw in the bolt (1) and tighten up
N
Unscrew stop pin (3)
N
3
Turn the guard so that it is in the
N
position shown (see picture)
Screw in and tighten the stop pin (3)
N
Install the adjusting lever
N
Mount "cast arm with guard" – guard
N
on the inboard side
Install the V-belt guard
N
Connect water connection
N
Check the adjustment range of the
guard
A
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
TS 410, TS 420