Cut-Off Machine Cart - Stihl TS 410 Manual De Instrucciones

6
1
5
1 1
Unscrew the nuts (1)
N
Remove the starter cover (5)
N
Do not remove the "cast arm and
N
guard" (6) – hold it in place on the
studs until the starter cover is fitted
back in position
Remove the defective V-belt
N
7
8
Carefully insert the new V-belt (7)
N
on the V-belt pulley (8) on the
engine and the front V-belt
pulley (9)
NOTICE
The belt action must run smoothly.
TS 410, TS 420
10
5
1
Fit the starter cover (5) over the
N
studs (10)
Tighten up the nuts (1) by hand
N
Push the V-belt guard (4) into place
9 N
Screw in the bolt (3) and tighten up
N
Insert the water hose into the guide
N
in the V-belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Continue as described in the chapter
"Tensioning the V-belt".
10
10
1
1
4
3
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
–
–
–

Cut-off machine cart

repair damaged roadways
apply roadway markings
cut expansion joints
English
41