Stihl TS 410 Manual De Instrucciones página 28

English
Removing the V-belt guard
2
1
Remove screw (1)
N
Raise the V-belt guard (2) slightly
N
and pull it off to the front
3
Remove the V-belt (3) from the front
N
pulley (4)
26
Remove the "cast arm with guard"
2
1
4
Unscrew the nuts (1)
N
Remove the "starter cover with
N
rewind starter" (2)
Remove the "cast arm with
N
guard" (3) from the studs
Preparing the "cast arm with guard" for
outboard mounting
Unscrew stop pin (1)
N
4 5
3
N
N
N
1
N
N
1
N
4 5
N
N
1
N
1
Turn the guard so that it is in the
position shown (see picture)
Screw in and tighten the stop pin (1)
Move the adjusting lever (2) to
position A
Screw in the bolt (3) and tighten up
Unscrew the bolt (4) of the limit
stop (5)
Remove the limit stop (5)
6
Turn the "cast arm with guard" so
that the guard is on the outboard
side
Insert limit stop (5) – align the hole
in the limit stop with the hole in the
cast arm
Screw in the bolt (4) and tighten up
TS 410, TS 420
A
3 2