Technical Data; Accuracy; Ambient Conditions; Supply Voltage - Balluff Micropulse BTL6-V11V-M Serie Manual De Instrucciones

BTL6-V11V-M _ _ _ _ -A/B/Y/Z(8)-S115
Micropulse Transducer - Rod Style
7

Technical data

7.1

Accuracy

The specifications are typical values at 24 V DC and room
temperature, with a nominal length of 500 mm in
conjunction with the BTL-P-1013-4R, BTL-P-1013-4S,
BTL-P-1012-4R, or BTL-P-1014-2R magnet.
The BTL is fully operational immediately, with full accuracy
after warm-up.
For special versions, other technical data may
apply.
Special versions are indicated by the suffix -SA
on the part label.
Resolution
Repeat accuracy, typical
Sampling rate
Dependent on nominal length
At nominal length = 500 mm
Non-linearity at
Nominal length ≤ 500 mm
Nominal length > 500 mm
Temperature coefficient
1)
7.2

Ambient conditions

Operating temperature
Storage temperature
Relative humidity
Shock rating
per EN 60068-2-27
2)
Continuous shock
per EN 60068-2-29
2)
Vibration
per EN 60068-2-6
2)
(note resonant frequency
of the rod)
Degree of protection per
IEC 60529 (when attached)
7.3

Supply voltage

Voltage, stabilized
3)
Ripple
Current draw
(at 24 V DC)
Inrush current
Reverse polarity protection
Overvoltage protection
Dielectric strength of
GND to housing
www.balluff.com
< 15 µm
< 20 µm
250 µs to 3.5 ms
≥ 0.5 ms
±200 µm
±0.04 % FS
≤ 20 ppm/K
0°C to +70°C
−40°C to +100°C
< 90%, non-condensing
50 g/6 ms
50 g/2 ms
12 g, 10 to 2000 Hz
IP 67
20 to 28 V DC
≤ 0.5 V
ss
≤ 75 mA
≤ 4 A/0.5 ms
Up to 36 V
Up to 36 V
(supply cables only!)
500 V DC
7.4

Inputs/outputs

Short circuit resistance
7.5

Dimensions, weights

Rod diameter
Nominal length
For Ø 8 mm
For Ø 10.2 mm
Weight (depends on
length)
Housing material
Rod material
Rod wall thickness
For Ø 8 mm
For Ø 10.2 mm
Young's modulus
Housing mounting via
threads
Tightening torque
Nominal length 500 mm, magnet in the middle of the measuring range
1)
Individual specifications as per Balluff factory standard
2)
For : The transducer must be externally connected via a limited-
3)
energy circuit as defined in UL 61010-1, a low-power source as defined in
UL 60950-1, or a class 2 power supply as defined in UL 1310 or
UL 1585.
Signal cable to GND
8 mm or 10.2 mm
25 to 1016 mm
25 to 4012 mm
Approx. 2 kg/m
Anodized aluminum
Stainless steel 1.4571
0.9 mm
2 mm
Approx. 200 kN/mm
2
M18×1.5 or 3/4"-16UNF
Max. 100 Nm
english 13