Publicidad
Idiomas disponibles
Idiomas disponibles
values* of 64 to 940 are converted to the video levels
of 0 to 100% to display an image on the projector.
When "RGB FULL" or "YPbPr FULL" is selected, in
the case that a 10-bit HD-SDI signal is input and
"Contrast" is set to 90 in "Signal Adjust" of the
PICTURE CONTROL window, mapping is done so
that HD-SDI signal data values* of 0 to 1023 are
converted to the video levels of 0 to 100% to display
an image on the projector. In this case, inhibition
codes included in a 10-bit HD-SDI signal (data area 0
to 3, and 1020 to 1023) are blocked out.
* Data value 64 of a 10-bit HD-SDI signal input is
equivalent to the video level of 0% (white), and data value
940 equivalent to 100% (black).
I/P Mode: Selects the I/P conversion mode. Depending on
the input signal source, set the mode to "Interlace" or
"PsF."
Note
This item is available with the interlace or PsF signal
input.
Signal Info (Information)
Shows the horizontal and vertical frequencies of the input
signal automatically. The values are approximate.
The type of the input signal is also displayed.
fH: Displays the horizontal frequency.
fV: Displays the vertical frequency.
Signal Adjust
Adjusts the picture quality of the input signal.
Clicking
increases the setting value, and
decreases it.
Clicking the RESET button resets all the settings to the
factory preset values.
Contrast: Adjusts the picture contrast. The higher the
setting, the greater the contrast.
Brightness: Adjusts the picture brightness. The higher the
setting, the brighter the picture.
Color: Adjusts the color intensity. The higher the setting,
the greater the intensity.
Sharpness: Adjusts the picture sharpness. The higher the
setting, the sharper the picture. The lower the setting,
the softer the picture.
22
GB
COLOR/FRAME Window
COLOR/FRAME Window
The COLOR/FRAME window is used to adjust the input
signal.
When the screen mode is set to "dual-screen" or "quad-
screen," the items can be independently adjusted for each
input channel displayed on the screen.
Board
Shows the input board installed in the relative input board
slot of the projector.
Color
Adjusts the items so that you can obtain precise color
reproduction.
If the color of an image is not correct, check the setting of
"Color Space" first.
Select the setting from the drop-down list displayed by
clicking
.
Color Space: Selects the color gamut.
709: Select when projecting a normal high-definition
signal or RGB signal.
DCDM: Select when projecting a signal source using
the Minimum D-Cinema Color Gamut defined by the
DCI Specifications Book/Version 1.0.
CIEXYZ: Select when projecting a special signal
source with wider color gamut than that of "DCDM,"
such as a 12-bit XYZ signal.
Color Temp (temperature): Selects the color
temperature from among "DCI W/P," "6500,"
"CUSTOM1," "CUSTOM2," "CUSTOM3" and
Publicidad
Capítulos
