Picture Control Window; Board; Input Source - Sony SRX-R110 Manual De Instalación

About the items that cannot be adjusted
Items that cannot be adjusted depending on the input signal
are not displayed in the window.
For details, see "Input Signals And Adjustable/Setting
Items" on page 29.
PICTURE CONTROL
Window
The PICTURE CONTROL window is used to select the
input source or to adjust the picture quality.
When the screen mode is set to "dual screen" or "quad
screen," the items can be independently adjusted for each
input channel displayed on the screen.

Board

Shows the input board installed in the relative input board
slot of the projector.

Input Source

Signal Mode: Click to open the drop-down list to
select the type of signal input from equipment
connected to the optional input board.
When the LKRI-001 is installed
Select "YPbPr" to input a high-definition signal from
component equipment, and "RGB" to input a high-
definition signal from video GBR equipment.
When the LKRI-003 is installed
For Single-link input, select "YPbPr" or "YPbPr
FULL."
For Dual-link input, select "RGB" or "RGB FULL."
When "RGB" or "YPbPr" is selected, in the case that
a 10-bit HD-SDI signal is input and "Contrast" is set
to 90 in "Signal Adjust" of the PICTURE CONTROL
window, mapping is done so that HD-SDI signal data

PICTURE CONTROL Window

21
GB